-
Finished another premade paws using my new 5-finger pattern. These are super comfy for small hands.
-
Completed ankle length king cheetah tail. Features a reinforced gore cutoff end for a standard sized belt and detail fur trimming.
-
Paw parts and a tail gore piece all ready for install on their respective pieces. Doing all this took a goodly few hours and several mis-spooled bobbins
-
I am continuing on my quest to generate a ‘perfect’ bear paw pattern. We’ll see how this new pattern test goes. If it doesn’t meet my standards for a bear paw I think i’ll try modifying MissrarsCreatures 5-finger pattern.
-
Working on another pre-made tail, just because. This one is a king cheetah.
-
Finished some pre-made paws. The fur is super dooper soft and each paw has a right/left label
-
Did some work on these paws over the weekend. I have decided I definitely hate this blue fur as it’s so darn slippery!
-
This paint job looks much better than previous, more alive. These are the completed antlers for the jackalope project.
-
Completed snow leopard tail. This is huge (148cm) featuring a gore cap and weighted tip. Rosettes are all hand sewn and has detail trimming to show these off.
-
Whelp, the original gore cap was too large and failed in holding the tails weight up. So I’m redesigning with a single reinforced belt ‘tube’ and I inserted a 3” foam block at the tail base for stability. So far, it looks like it’ll work well.